What are the specific functions of fir wood piles for protecting large trees? Without further ado, let’s read on.

In everyone's mind, fir wood piles are very cost-effective and can be used in construction engineering design and construction, water conservancy construction, furniture product manufacturing, greening support capacity, etc.

1. Support: Due to the large crown, high center of gravity and small root system of large-sized trees, they cannot be fixed by the tree itself and are easily blown down or tilted by the wind. Even if the tree body shakes, it is easy to cause the roots to shake, making the roots unable to take root. Or the roots will rot after air dew. Therefore, after the large trees are planted, they must be supported. Large bamboo poles or fir poles are generally used to support large trees, depending on the size and height of the tree. In this project, 3 fir stakes are generally used for large trees. Angular or 4-corner symmetrical support. The bottom of the bamboo pole is fixed with short wooden stakes and supports to prevent it from sliding in the wind. The bamboo pole and the support part of the tree body are tied firmly with hemp rope. The support part of the tree should be surrounded and protected with brown leather or straw rope. , so as not to damage the bark of the tree, the Taizhou fir pile is supported at the end, and the tree body is swayed hard, the tree body is strong and does not sway.

2. Prevent diseases and pests: Adhere to the principle of focusing on prevention and combining prevention and treatment, and conduct frequent inspections and preventive measures based on the characteristics of tree species and the occurrence and development patterns of pests and diseases. Once the disease occurs, it is necessary to prescribe the right medicine and prevent and control it in time.

3. Fertilization: Fertilization is helpful to restore tree vigor. In the early stage of transplantation of large trees, the root system has low fertilizer absorption capacity, so it is advisable to use extra-root top dressing, usually once every half a month. Urea, ammonium sulfate, potassium dihydrogen phosphate, etc. are very effective. Fertilizer is prepared into a fertilizer solution with a concentration of 0.5% to 1%. Spray on the leaves in the morning and evening or on cloudy days. Spray again in case of rainfall. After the root system germinates, the soil can be fertilized. It is required to apply thin fertilizer frequently to prevent damage to the roots. .

4. Anti-freeze: The branches of newly planted large trees have delayed root germination, short annual growth cycle, and little accumulated nutrients. Therefore, the tissue is not substantial and is susceptible to low temperature damage. Anti-freeze and heat preservation work should be done. On the one hand, after autumn, It is necessary to control nitrogen fertilizer, apply more phosphorus fertilizer and potassium fertilizer, and gradually extend the lighting time and increase the lighting intensity to improve the lignification degree of the tree and improve its own cold resistance. Secondly, before the cold wave comes in winter, the tree should be well insulated. Work. You can protect it by covering it with soil, covering the ground, setting up wind barriers, building plastic greenhouses, etc.

The above is all about the use of fir stakes for large tree protection. Follow this site and there will be articles to share in the future.