\u003Ci>近年,随着生活水平的进步．\u003C\/i> \u003Cb>In recent years, with the improvement of living standards.\u003C\/b>\u003Ci>河道护岸仿木桩的使用也大大进步了,人们对水环境的要求也越来越高．\u003C\/i> \u003Cb>The use of imitation wood piles for river bank protection has also been greatly improved, and people's requirements for the water environment are getting higher and higher.\u003C\/b>\u003Ci>河道已不仅仅有"泄洪,排涝,蓄水,引清,航运"等基本功能,而且还具有"景观,旅行,生态,与周边环境照应"等功能.人们渴望见到水清天蓝,绿树夹岸,鱼虾洄游的自然景观.\u003C\/i> \u003Cb>Rivers no longer only have basic functions such as "flood discharge, drainage, water storage, water diversion, and navigation", but also have functions such as "landscape, travel, ecology, and care for the surrounding environment". People are eager to see clear water, blue sky, and green trees. Along the shore, there is a natural landscape of fish and shrimp migratory.\u003C\/b>

Traditional rigid structural hydraulic slope protection is widely used in cast-in-place concrete, asphalt concrete, mortar block stones, independent concrete block stone pavements, anti-erosion protection surfaces made of marl, etc. Residential load-bearing wooden floors, roof tiles, river wood Most of the fir wood strips used in piles are used directly after sawing logs, and some are laminated veneer lumber, which are used directly after sawing. In order to improve its load-bearing effect, they are usually solved by thickening or increasing the number of wooden strips. A simple method is proposed. This easy method, without increasing the thickness of the board, greatly improves the bearing capacity of the river wooden piles and solves the bending and deformation problem of the river wooden piles. It is feasible, reliable and economical to reinforce the load-bearing square slabs. , can save a lot of wood consumption.

On the longitudinal center line of end 2 of the stress-bearing surface of the wooden pile in the river, a straight steel bar is firmly fixed at end 2 of the steel bar close to end 2 of the strip. The wooden strip and the steel bar are in close contact and tightly combined.

The cross-section is located at the longitudinal center line of the force surface and the opposite side of the force surface. The longitudinal center line of the force surface is the distance between the two long sides of the force surface, and the two long sides are equal and parallel. The longitudinal center line of the load-bearing back refers to the two long sides of the load-bearing back. Lines of equal length between long sides that are parallel to the two long sides.